Cart
Your cart is empty
We are delighted to welcome you to this page dedicated to replacing split magazine lips.
You've come to the right place to find out how to install magazine lips simply and effectively.
Information:
Hardware required for installation:
Important:
Always wear protective eyewear when handling airsoft products.
1
To begin, place your magazine on a stable surface.
2
Use a 2.5mm hex key to completely unscrew the screw located at the back of the base pad.
To prevent the spring from ejecting the magazine body, firmly hold the base pad and the magazine body.
3
Remove the base pad, taking into account the resistance of the spring.
4
Remove the magazine spring.
5
Remove the follower button.
6
To remove the magazine lips, use a 1.5mm hex key to remove the two screws holding them.
During assembly, please follow the same procedure in reverse order.
Thank you for following our installation guide.
Do not hesitate to consult our FAQ in case of difficulties or if you need additional assistance.
