Cart
Your cart is empty
We are delighted to welcome you to this page dedicated to the installation of 3D split magazine.
Information :
Hardware required for installation :
Important :
Always wear protective eyewear when handling airsoft products.
1
To begin, position your magazine on a stable surface.
2
Detach the block of parts located at the back of the magazine by rotating as indicated.
3
Separate each part of the block one by one by rotating them.
4
Cut off any protruding connecting rods from each of the pieces.
5
Insert the follower button into the magazine.
6
Insert the magazine spring.
7
Place the magazine locking piece in the indicated direction.
8
Push the spring and locking piece into the magazine, then slide the magazine base plate until the assembly locks into place.
9
Congratulations! the installation is now complete.
Thank you for following our installation guide.
Do not hesitate to consult our FAQ in case of difficulties or if you need additional assistance.
